|2009 National Renewable Energy Labratory/Boston Redevelopment Authority Topographic LiDAR: Boston, Massachusetts|
|The Alliance for Sustainable Energy, LLC contracted with Sanborn to provide LiDAR mapping services for the Boston area. Utilizing multi-return systems, Light Detection and Ranging (LiDAR) data in the form of 3-dimensional positions of a dense set of mass points was collected for approximately 90 square miles. All systems consist of geodetic GPS positioning, orientation derived from high-end inertial sensors and high-accurate lasers. The sensor is attached to the aircraft?s underside and emits rapid pulses of light that are used to determine distances between the plane and terrain below. Specifically, the Leica ALS-50 LiDAR system was used to collect data for the survey campaign. The LiDAR system is calibrated by conducting flight passes over a known ground surface before and after each LiDAR mission. During final data processing, the calibration parameters are inserted into post-processing software. Lidar Acquisition Parameters: Instrument: Leica ALS50 Flight Altitude: ~ 1500m AGL Airspeed: ~ 120 Knots Scan Frequency: 46 Hertz Pulse Rate: 74,400 Hertz Scan Width Half Angle: 25 Degrees Sidelap: 30% This Lidar survey acheived a point spacing of 1.0 meter.|
|Get the Data|
|Access||Format(s)||Distributor(s) / Contact Info||Instructions / Constraints|
- Format version:
(version is unknown)
(organisationName is template)
- Ordering Instructions
- The National Geophysical Data Center serves as the archive for this LIDAR data. NGDC should only be contacted for this data if it cannot be obtained from NOAA Coastal Services Center.
- The National Geophysical Data Center serves as the archive for this LIDAR dataset. NGDC should only be contacted for the data if it cannot be obtained from NOAA Coastal Services Center.